Fusion FWD L4-2.5L Hybrid (2010)
3. Remove the high-voltage cable connector and bracket. For additional information, refer to High-Voltage Traction Battery Connector and Bracket
See: Battery, Hybrid Drive/Service and Repair/High-Voltage Traction Battery Connector and Bracket.
4. Release the locking tabs and disconnect the 3 connectors.
5. Remove the 2 HVTB cable nuts and detach the cables from the high-voltage Bussed Electrical Center (BEC).
-
To install, tighten to 15 Nm (133 lb-in).
6. Remove the nut at the upper LH corner and remove the high-voltage BEC.
-
To install, tighten to 9 Nm (80 lb-in).
7. To install, reverse the removal procedure.
