ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3173 > < Initial Inspection and Diagnostic Overview|Page 3171
Page 22
background image

-

Are the voltages greater than 10 volts?

Yes

GO to G2. 

No

For 3.5L gasoline, VERIFY the Battery Junction Box (BJB) fuse 16 (15A) or Smart Junction Box (SJB) fuse 44 (10A) is OK. For 2.5L hybrid,
VERIFY the BJB fuse 23 (10A) or fuse 39 (10A) is OK. If OK, REPAIR the circuit in question. If not OK, REFER to the Wiring Diagrams to identify
the possible causes of the circuit short  See: Diagrams/Electrical Diagrams/Diagrams By Number. CLEAR the DTCs. REPEAT the network test with the
scan tool.

-------------------------------------------------
G2 CHECK THE TCM GROUND CIRCUITS FOR AN OPEN

 

-

Ignition OFF.

-

Disconnect: Negative Battery Cable .

-

For 3.5L gasoline, measure the resistance between the TCM C1533-9, circuit GD120 (BK/GN), harness side and ground.

-

For 2.5L hybrid measure the resistance between the TCM C1458a-2, circuit GD121 (BK/YE), harness side and ground; and between the TCM
C1458a-8, circuit GD121 (BK/YE), harness side and ground.

-

Are the resistances less than 5 ohms?

Yes

For 3.5L engine, GO to G3. 

Initial Inspection and Diagnostic Overview|Page 3173 > < Initial Inspection and Diagnostic Overview|Page 3171