Fusion FWD L4-2.5L Hybrid (2010)
-
Disconnect the SOD-L connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the SOD-L connector and make sure it seats correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new SOD-L. REFER to Fire Suppression System. CONNECT all modules. CLEAR the DTCs. CONNECT all modules. REPEAT the
network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CONNECT all modules. REPEAT
the network test with the scan tool.
-------------------------------------------------
AC68 CHECK FOR CORRECT SOD-R OPERATION
-
Disconnect the SOD-R connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the SOD-R connector and make sure it seats correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new SOD-R. REFER to Fire Suppression System. CONNECT all modules. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CONNECT all modules. CLEAR
the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
Pinpoint Test AD: Intermittent No High Speed CAN (HS-CAN) Communication, One + Modules Are
Not Responding During Network Test
Communications Network
Pinpoint Tests
Pinpoint Test AD: Intermittent No High Speed Controller Area Network (HS-CAN) Communication, One Or More Modules Are Not
Responding During Network Test
Normal Operation
When one of the 2 High Speed Controller Area Network (HS-CAN) circuits becomes open to a module on the network, intermittent or unreliable
communication to all modules on the HS-CAN may result.
The following modules communicate on the HS-CAN:
-
4X4 control module (if equipped)
-
ABS module
