ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3286 > < Initial Inspection and Diagnostic Overview|Page 3284
Page 135
background image

GO to AE32.

-------------------------------------------------
AE32 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE RCM DISCONNECTED

 

-

Disconnect: Restraints Control Module (RCM) C310b .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AE46. 

No

If the vehicle is equipped with a Power Steering Control Module (PSCM), GO to AE33. 

If the vehicle is not equipped with a PSCM, GO to AE34.

-------------------------------------------------
AE33 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE PSCM DISCONNECTED

 

-

Disconnect: Power Steering Control Module (PSCM) C1467b .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AE47. 

No

GO to AE34.

-------------------------------------------------
AE34 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE OCSM DISCONNECTED

 

-

Disconnect: Occupant Classification System Module (OCSM) C3159 .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

Initial Inspection and Diagnostic Overview|Page 3286 > < Initial Inspection and Diagnostic Overview|Page 3284