ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3287 > < Initial Inspection and Diagnostic Overview|Page 3285
Page 136
background image

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AE48. 

No

If the vehicle is equipped with a Transmission Control Module (TCM), GO to AE35. 

If the vehicle is not equipped with a TCM, GO to AE36.

-------------------------------------------------
AE35 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE TCM DISCONNECTED

 

-

Disconnect: TCM C1458a (Hybrid) or C1533 (3.5L) .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AE49. 

No

GO to AE36.

-------------------------------------------------
AE36 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE IPC DISCONNECTED

 

-

Disconnect: IPC C220 .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to AE50. 

No

Initial Inspection and Diagnostic Overview|Page 3287 > < Initial Inspection and Diagnostic Overview|Page 3285