Fusion FWD L4-2.5L Hybrid (2010)
Flywheel: Removal and Replacement
Flywheel
Flywheel
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the engine. For additional information, refer to Engine See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine - Removal.
3. Remove the 6 bolts and the flywheel.
Installation
1. NOTE: Special bolts are used for installation. Do not use standard bolts.
Install the flywheel and tighten the bolts in the sequence shown in the following 3 stages:
-
Stage 1: Tighten to 50 Nm (37 lb-ft).
-
Stage 2: Tighten to 80 Nm (59 lb-ft).
-
Stage 3: Tighten to 112 Nm (83 lb-ft).
2. Install the engine. For additional information, refer to Engine See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine - Removal.
Exploded View - Flywheel and Crankshaft Rear Oil Seal
Lower End Components - Exploded View
Crankshaft Pulley and Crankshaft Front Oil Seal