Fusion FWD V6-3.0L (2009)
Condenser HVAC: Service and Repair
Condenser Core
Removal and Installation
NOTE: New A/C condenser service parts are shipped with a new receiver/drier cartridge installed in the integral receiver/drier.
1. Recover the refrigerant.
2. With the vehicle in NEUTRAL position it on a hoist.
3. Remove the cooling fan.
4. Remove the washer reservoir filler neck bolt.
5. Remove the 2 condenser fitting nuts and disconnect the fittings.
-
Discard the gasket seals.
-
To install, tighten to 15 Nm (133 lb-in).
