ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3016 > < Initial Inspection and Diagnostic Overview|Page 3014
Page 47
background image

R10 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE IC DISCONNECTED

-

Disconnect: IC C220.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to R11.

No

CONNECT the negative battery cable. GO to R48.

-------------------------------------------------
R11 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE ACM DISCONNECTED

-

Disconnect: Audio Control Module (ACM) C290c (Base Audio/Audiophile) or C240c (THX(R) Audio/Navigation).

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to R12.

No

CONNECT the negative battery cable. GO to R49.

-------------------------------------------------
R12 VERIFY VEHICLE EQUIPMENT - AUDIO DSP MODULE

-

Inspect the vehicle for an audio Digital Signal Processing (DSP) module.

-

Is the vehicle equipped with an audio DSP module?

Yes

GO to R13.

No

GO to R14.

-------------------------------------------------
R13 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE AUDIO DSP MODULE
DISCONNECTED

-

Disconnect: Audio DSP Module C4326c.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

Initial Inspection and Diagnostic Overview|Page 3016 > < Initial Inspection and Diagnostic Overview|Page 3014