ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Trailing Arm Bushing > < Rear Wheel Bearing

Galaxy 2000.75 (04.2000-02.2006)

Rear Suspension - Trailing Arm Galaxy 2000.75 (04/2000-02/2006)
Removal and Installation

General Equipment
Transmission Jack
Brake Hose Clamp

Removal

  1. Remove the wheel bearing.
    For additional information, refer to Wheel Bearing in this section.

  1. Detach the brake hose from the brake backing plate.
    1. Disconnect the brake tube union.
    1. Remove the brake hose retaining clip.
    1. Release the brake hose from the bracket.

  1. Remove the rear brake disc shield from the trailing arm.

  1. Using a suitable brake hose clamp, clamp the brake hose.

  1. CAUTION:
    CAUTION:Cap the brake tube to prevent fluid loss and dirt ingress.
    Detach the brake tube from the trailing arm.
    1. Disconnect the brake tube union.
    1. Remove the brake hose retaining clip.
    1. Detach the brake tube from the trailing arm.

  1. Detach the wheel speed sensor wiring harness from the trailing arm.
    1. Detach the cable from the protective sleeve.
    1. Detach the cable from the clamps.

  1. Disconnect the parking brake cable from the trailing arm.
  1. Remove the spring.
    For additional information, refer to Spring in this section.

  1. Detach the headlamp levelling sensor connecting link from the trailing arm (if equipped).

  1. Remove the trailing arm.

Installation

  1. To install, reverse the removal procedure.
  1. Bleed the brake system. For additional information, refer to Section  206-00 Brake System - General Information.

Trailing Arm Bushing > < Rear Wheel Bearing