General Procedures Vehicles with Front Parking Aid | -
NOTE:The object used in this system check can be fabricated from a 7.62 cm diameter pipe, 99.06 cm in height. NOTE:The following system check should be carried out with the vehicle on a level surface. NOTE:The parking aid system will switch on when the ignition switch is turned from position 0 to position II. Turn the ignition switch to position II. | | -
Verify the parking aid system detects the object (7.62 cm diameter pipe 99.06 cm high) when placed in the five specified locations (P1, P2, P3, P4, P5). | Vehicles with Rear Parking Aid | -
NOTE:The object used in this system check can be fabricated from a 7.62 cm diameter pipe, 99.06 cm in height. NOTE:The following system check should be carried out with the vehicle on a level surface. NOTE:The parking aid system will switch on when the ignition switch is turned from position 0 to position II. Turn the ignition switch to position II. | | -
Place the gear shift in reverse. | | -
Verify the parking aid system detects the object (7.62 cm diameter pipe 99.06 cm high) when placed in the five specified locations (P1, P2, P3, P4, P5). | |