Removal and Installation Removal | -
Remove the RH splash shield. | | -
If equipped, disconnect the engine block heater electrical connector. | | -
CAUTION:Plug all ports to prevent contamination from dirt or moisture. If equipped with the 3.0L (4V) engine, remove the A/C manifold and tube assembly bolt and disconnect the A/C manifold and tube. | | -
NOTE:Vehicles with the 2.0L Zetec engine shown, vehicles with the 3.0L (4V) engine similar. Remove the A/C compressor pressure relief valve. | | -
To install, reverse the removal procedure. - Lubricate the O-ring seals with PAG Compressor Oil YN-12-C or equivalent meeting Ford specification WSH-M1C231-B.
| | |