General Procedures | -
Body frame dimensions - All dimensions with tolerance ± 3 mm. The detailed illustrations all depict the left-hand side of the vehicle.
- All dimensions were determined from the centre of the hole using a symmetrically adjusted beam trammel and with assemblies removed.
- Measuring points 1, 3 and 4 are on the side of the side member whilst all other measuring points are on the underside.
| | -
Body frame dimensions - All dimensions with tolerance ± 3 mm. The detailed illustrations all depict the left-hand side of the vehicle.
- All dimensions were determined from the centre of the hole using a symmetrically adjusted beam trammel and with assemblies removed.
| | |