Removal and Installation Removal and Installation | -
Position the steering wheel in the straight-ahead position and remove the ignition key. - Rotate the steering wheel until the steering column locks into position.
| | -
Position the steering column boot aside. | | -
Remove the steering column coupling upper pinch bolt. - To install, tighten to 25 Nm (18 lb-ft).
| | -
If equipped, disconnect the passive anti-theft system (PATS) transceiver module electrical connector. | | -
Disconnect the wiring harness from the steering column. | | -
Disconnect the 2 electrical connectors. | | -
Remove the 4 steering column mounting bolts. - To install, tighten to 25 Nm (18 lb-ft).
| | -
Remove the steering column assembly. | | -
To install, reverse the removal procedure. | | |