ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
3 Powertrain > < Ignition Switch - Vehicles Built From: 12-2003

Maverick 2005 (08.2004-)

Steering Column Switches - Steering Column Lock Module—Vehicles Built From: 12/2003 Maverick 2005 (08/2004-)
Removal and Installation

Removal and Installation

CAUTION:
CAUTION:Do not remove the ignition lock cylinder and the ignition switch at the same time or damage to the column may result.
  1. Remove the ignition switch. For additional information, refer to Ignition Switch in this section.

  1. NOTE:
    NOTE:Clean all metal shavings and debris after cutting slots in the steering lock module bolts.
    Cut slots into the heads of the 2 steering lock module bolts.
  1. Remove the 2 steering lock module bolts.
    • Discard the steering lock module bolts.
  1. Remove the steering lock module clamp.
  1. Remove the steering lock module.
  1. To install, reverse the removal procedure.
    • Align the ribs on the steering lock module with the window of the steering column tube.
    • Align the locating pin with the slot on the locating bracket of the steering column.
    • Tighten the steering lock module bolts until the heads of the bolts shear off.

3 Powertrain > < Ignition Switch - Vehicles Built From: 12-2003