ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Cylinder Head LH - Vehicles Built From: 12-2004 > < Crankshaft Front Seal - Vehicles Built From: 12-2003

Maverick 2005 (08.2004-)

Engine - 3.0L Duratec-VE (VE6) - Crankshaft Rear Seal—Vehicles Built From: 12/2003 Maverick 2005 (08/2004-)
In-vehicle Repair

Special Tool(s)

Slide Hammer

307-005 (T59L-100-B)

Remover, Crankshaft Rear Seal

303-519 (T95P-6701-DH)

Installer, Crankshaft Rear Main Oil Seal

303-178 (T82L-6701-A)

Installer Bolts, Crankshaft Rear Main Oil Seal

303-384 (T91P-6701-A)
Materials
Name
Specification
SAE 5W-20 Premium Synthetic Blend Motor Oil
XO-5W20-QSP or equivalent
WSS-M2C930-A
Metal Surface Cleaner
F4AZ-19A536-RA or equivalent
WSE-M5B392-A

Removal

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02 Jacking and Lifting.
  1. Remove the flexplate. For additional information, refer to Flexplate in this section.

  1. Using the special tools, remove the crankshaft rear oil seal.

Installation
  1. NOTE:
    NOTE:Clean all sealing surfaces with metal surface cleaner.
    NOTE:
    NOTE:Lubricate the crankshaft rear oil lips with clean engine oil.
    Using the special tools, install the crankshaft rear oil seal.

Cylinder Head LH - Vehicles Built From: 12-2004 > < Crankshaft Front Seal - Vehicles Built From: 12-2003