ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
In-vehicle Repair|Removal > < Valve Spring, Retainer and Seal - Vehicles Built From: 12-2003

Maverick 2005 (08.2004-)

Engine - 3.0L Duratec-VE (VE6) - Engine Support Insulators—Vehicles Built From: 12/2004 Maverick 2005 (08/2004-)
In-vehicle Repair

Special Tool(s)

3-Bar Engine Support Kit

303-F072

Lifting Brackets, Engine

303-050 (T70P-6000)

Universal Adapter Brackets

014-0001

 
Item
Part Number
Description
1
N621942
Power steering pressure (PSP) tube bracket nut
2
—
PSP tube bracket (part of 3A719)
3
N621942
Engine support insulator bracket nuts (3 required)
4
W709667
Engine support insulator bracket bolt
5
—
Engine support insulator bracket
6
W500233
Engine support insulator bolts (3 required)
7
6068
Engine support insulator

Removal and Installation

  1. Remove the lower intake manifold. For additional information, refer to Lower Intake Manifold in this section.
  1. Remove the engine support insulator bracket bolt.
    • To install, tighten to 90 Nm (66 lb-ft).
  1. Install the special tools.
    1. Position the 2 universal adapter brackets on top of the cylinder block.
    1. Install 2 M8 x 1.25 x 36 mm (1.41 in) bolts and tighten to 10 Nm (89 lb-in).
    1. Position the universal lifting bracket onto the 2 universal adapter brackets.
    1. Fasten the universal lifting bracket to the 2 universal adapter brackets with a suitable nut and bolt.

  1. Using the special tools, lift the engine 12 mm (0.47 in).

  1. Remove the nut and position the PSP tube bracket aside.
    • To install, tighten to 25 Nm (18 lb-ft).
  1. Remove the 3 nuts and the engine support insulator bracket.
    • To install, tighten to 55 Nm (41 lb-ft).
  1. Remove the 3 bolts and the engine support insulator.
    • To install, tighten to 48 Nm (35 lb-ft).
  1. To install, reverse the removal procedure.

In-vehicle Repair|Removal > < Valve Spring, Retainer and Seal - Vehicles Built From: 12-2003