ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Coolant Pump - Vehicles Built From: 12-2004 3.0L Duratec-VE (VE6) > < Coolant Pump - Vehicles Built From: 12-2003 2.3L Duratec-HE (MI4)

Maverick 2005 (08.2004-)

Engine Cooling - Coolant Pump—Vehicles Built From: 12/2003 3.0L Duratec-VE (VE6) Maverick 2005 (08/2004-)
Removal and Installation

 
Item
Part Number
Description
1
W525958
Clamp
2
6N734
Coolant pump-to-oil cooler hose
3
W701544
Coolant pump assembly bolt (3 required)
4
8287
Coolant pump-to-engine hose clamp
5
8501
Coolant pump assembly

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02 Jacking and Lifting.
  1. Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.
  1. Remove the coolant pump belt. For additional information, refer to Section 303-05A Accessory DriveSection 303-05B Accessory Drive.
  1. Remove the thermostat housing. For additional information, refer to Thermostat Housing — 3.0L (4V) in this section.
  1. Disconnect the oil cooler coolant hose from the coolant pump.

  1. Remove the 3 coolant pump assembly-to-engine bolts.
    • To install, tighten to 10 Nm (89 lb-in).
    • Tighten the 3 bolts an additional 90 degrees.
  1. Reposition the coolant pump-to-engine hose clamp.
    • Remove the coolant pump.
  1. To install, reverse the removal procedure.
  1. Fill and bleed the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.

Coolant Pump - Vehicles Built From: 12-2004 3.0L Duratec-VE (VE6) > < Coolant Pump - Vehicles Built From: 12-2003 2.3L Duratec-HE (MI4)