ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Spark Plugs - Vehicles Built From: 12-2003 > < Engine Ignition Components - Exploded View - Vehicles Built From: 12-2003

Maverick 2005 (08.2004-)

Engine Ignition - 3.0L Duratec-VE (VE6) - Ignition Coil-On-Plug—Vehicles Built From: 12/2003 Maverick 2005 (08/2004-)
Removal and Installation

Materials
Name
Specification
Silicone Brake Caliper Grease and Dielectric Compound
D7AZ-19A331-A (Motorcraft XG-3) or equivalent
ESE-M1C171-A

Removal and Installation

Both sides
  1. Disconnect the battery ground cable. For additional information, refer to Section 414-01 Battery, Mounting and Cables.
RH side
  1. NOTE:
    NOTE:The upper intake manifold must be removed to access the RH ignition coils only.
    Remove the upper intake manifold. For additional information, refer to Section 303-01A EngineSection 303-01B Engine.
Both sides
  1. Disconnect the ignition coil electrical connectors.
  1. Remove the bolts and the ignition coils.
    • To install, tighten to 15 Nm (11 lb-ft).
  1. To install, reverse the removal procedure.
    • Apply a small amount of dielectric grease to the inside of the ignition coil boots before attaching to the spark plugs.

Spark Plugs - Vehicles Built From: 12-2003 > < Engine Ignition Components - Exploded View - Vehicles Built From: 12-2003