ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Catalyst Monitor Sensor > < Mass Air Flow (MAF) Sensor - Vehicles Built From: 12-2003

Maverick 2005 (08.2004-)

Electronic Engine Controls - 3.0L Duratec-VE (VE6) - Heated Oxygen Sensor (HO2S) Maverick 2005 (08/2004-)
Removal and Installation

Special Tool(s)

Socket, Exhaust Gas Oxygen Sensor

303-476 (T94P-9472-A)
Materials
Name
Specification
High Temperature Nickel Anti-Seize Lubricant
XL-2 (US); CXG-2-B (Canada); or equivalent
ESE-M12A4-A
Penetrating and Lock Lubricant
XL-1 (US); CXC-51-A (Canada)
—

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02 Jacking and Lifting.
  1. Disconnect the battery ground cable. For additional information, refer to Section 414-01 Battery, Mounting and Cables.

  1. Remove the 7 bolts and the LH splash shield.
    • To install, tighten to 10 Nm (89 lb-in).
  1. Disconnect the heated oxygen sensor (HO2S) electrical connector.

  1. NOTE:
    NOTE:If necessary, lubricate the sensor threads with penetrating and lock lubricant to assist in removal.
    Using the special tool, remove the HO2S.
    • To install, tighten to 48 Nm (35 lb-ft).
  1. NOTE:
    NOTE:Apply a light coat of anti-seize lubricant to the threads of the HO2S.
    To install, reverse the removal procedure.

Catalyst Monitor Sensor > < Mass Air Flow (MAF) Sensor - Vehicles Built From: 12-2003