Ford Workshop Service and Repair Manuals

Sizer, Hub Seal

307-283 (T94P-77000-D4)

1. 

   CAUTION:The tabs on the No. 2 direct clutch thrust washer must be seated in the direct clutch support and spring.
   Install the No. 2 direct clutch thrust washer on the forward/coast/direct clutch cylinder with the tabs facing downward.

2. Install the 2 reverse clutch cylinder seals.

3. 

   NOTE:Make sure that the reverse clutch cylinder seals are overlapped correctly.
   Position the reverse clutch cylinder seals.
   1. Correct installation.
   2. Incorrect installation.

4. Support the forward/coast/direct clutch cylinder assembly on a block of wood so that the direct clutch faces upward.

5. Install the direct clutch hub and shell on the forward/coast/direct clutch cylinder.

6. Install the reverse clutch drum assembly.

7. Install the reverse clutch hub.

8. Support the reverse clutch drum on a block of wood while installing the reverse clutch hub retaining ring.

9. Install the forward/coast/direct clutch cylinder hub seal.

10. Leave special tool attached until the forward/coast/direct clutch cylinder is installed into the transaxle housing.