Removal and Installation Name Specification Multi-Purpose Grease XG-4 and/or XL-5 ESB-M1C93-B Removal | -
Place the selector lever in the (D) position. | | -
Gently pry up to remove the upper selector lever trim ring. | | -
Remove the top finish panel. | | -
Remove the knob and wiring by pulling straight up on the knob. | | -
Remove and discard the shifter straw by pulling it straight up. | Installation | -
Lightly lubricate the shifter straw with multi-purpose grease, and install it into the shifter bore by pushing straight down. | | -
Feed the overdrive cancel switch electrical connector wire harness into the opening in the bezel and install the knob. | | -
Install the top finish panel. | | -
Install the upper shift lever trim ring. - To install the upper shift lever trim ring, orient the thick tab on the driver side front of the shifter and press into place.
| | -
Move the shifter through all gears from PARK to DRIVE several times, making sure that the shift knob set screw is not too tight. | | |