ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Transaxle Rear Support Insulator - Vehicles Built From: 12-2004 > < Transaxle LH Support Insulator - Vehicles Built From: 12-2004

Maverick 2005 (08.2004-)

Manual Transmission/Transaxle - Transaxle Front Support Insulator—Vehicles Built From: 12/2004 Maverick 2005 (08/2004-)
In-vehicle Repair

Special Tool(s)

3-Bar Engine Support Kit

303-F072 or equivalent

 
Item
Part Number
Description
1
W706899-S439
Transaxle front support insulator bolts (2 required)
2
W706899-S439
Transaxle front-to-aft crossmember bolts (2 required)
3
—
Splash shield screw
4
10852
Transaxle front-to-aft crossmember
5
W711268-S439
Transaxle front support insulator through-bolt
6
6E037
Transaxle front support insulator
7
W500321-S439
Transaxle front support insulator bracket bolts (3 required)
8
6A060
Transaxle front support insulator bracket

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02 Jacking and Lifting.

  1. Using the special tool, support the engine.

  1. Remove the front-to-aft crossmember.
    1. Remove the 2 transaxle front support insulator bolts.

        2. 1. To install, tighten to 90 Nm (66 lb-ft).

    1. Remove the splash shield screw.
    1. Remove the 2 front-to-aft crossmember bolts and the nut.

        2. 1. To install, tighten bolts to 90 Nm (66 lb-ft).

        2. To install, tighten nut to 175 Nm (129 lb-ft).

    1. Remove the crossmember.
  1. Remove the through-bolt and the transaxle front support insulator.
    • To install, tighten to 115 Nm (85 lb-ft).
  1. If necessary, remove the 3 bolts and the transaxle front support insulator bracket.
    • To install, tighten to 48 Nm (35 lb-ft).
  1. To install, reverse the removal procedure.

Transaxle Rear Support Insulator - Vehicles Built From: 12-2004 > < Transaxle LH Support Insulator - Vehicles Built From: 12-2004