ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
414-02 Generator and Regulator > < Battery Cables

Maverick 2005 (08.2004-)

Battery, Mounting and Cables - Battery Cables—Vehicles Built From: 12/2003 3.0L Duratec-VE (VE6) Maverick 2005 (08/2004-)
Removal and Installation

 
Item
Part Number
Description
1
14488
Starter solenoid terminal cover
2
W701596-S
Starter motor positive cable nut
3
W704141-S
Starter solenoid wire cable nut
4
—
Starter motor terminals (part of 14A280)
5
—
Battery ground cable-to-transaxle bolt
6
—
Battery ground cable terminal (part of 14A280)
7
13A506
Pin-type retainer
8
W520412-S
Battery junction box (BJB) terminal nut
9
—
BJB terminal (part of 14A280)
10
—
BJB electrical connector (part of 14A280)
11
N808023-S36M
Body ground terminal bolt
12
14A280
Battery cables

Removal and Installation

  1. Disconnect the battery. For additional information, refer to Battery Disconnect in this section.
  1. Remove the air cleaner assembly. For additional information, refer to Section 303-12A Intake Air Distribution and FilteringSection 303-12B Intake Air Distribution and Filtering.
  1. Remove the starter solenoid terminal cover.
  1. Remove the starter motor positive cable nut.
    • To install, tighten to 12 Nm (9 lb-ft).
  1. Remove the starter solenoid wire nut.
    • To install, tighten to 5 Nm (44 lb-in).
  1. Position the starter motor terminals aside.
  1. Remove the battery ground cable-to-transaxle bolt.
    • To install, tighten to 9 Nm (80 lb-in).
  1. Position the battery ground cable aside.
  1. Disconnect the retainers fastening the battery cables to the battery tray.
  1. Open the battery junction box (BJB) cover and remove the BJB terminal nut.
    • To install, tighten to 8 Nm (71 lb-in).
  1. Position the BJB terminal aside.
  1. Disconnect the BJB electrical connector.
  1. Remove the body ground terminal bolt from the left fenderwell.
    • To install, tighten to 9 Nm (80 lb-in).
  1. Release the battery cable locators and remove the battery cables from the vehicle.
  1. To install, reverse the removal procedure.

414-02 Generator and Regulator > < Battery Cables