ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
License Plate Lamp > < Fog Lamp

Maverick 2005 (08.2004-)

Exterior Lighting - Fog Lamp Bulb Maverick 2005 (08/2004-)
Removal and Installation

Removal and Installation

WARNING:
WARNING:The halogen fog lamp bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the bulb carefully. Grasp the bulb only by its base. Avoid touching the glass envelope. Failure to follow these instructions may result in personal injury.
CAUTION:
CAUTION:The fog lamp bulb should not be removed from the fog lamp until just before a new bulb is installed. Removing the bulb for an extended period of time may affect fog lamp bulb performance. Contaminants may enter the fog lamp where they can settle on the lens and reflector. Never turn on the fog lamps with the bulb removed.
NOTE:
NOTE:Make sure the headlamp switch and the ignition switch are in the OFF position.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02 Jacking and Lifting.
  1. Remove the 4 front fender splash shield bolts.
    • To install, tighten to 5 Nm (44 lb-in).
  1. Remove the 4 front fender splash shield pin-type retainers.
    • Position the front fender splash shield aside.
  1. Disconnect the fog lamp bulb electrical connector.
  1. Rotate the fog lamp bulb counterclockwise and remove the fog lamp bulb.
  1. To install, reverse the removal procedure.

License Plate Lamp > < Fog Lamp