Removal and Installation LH or RH Fenders | -
Remove the fender splash shield. For additional information, refer to Fender Splash Shield in this section. | RH Fender | -
Remove the antenna mast and the antenna base fender grommet. | LH or RH Fenders | -
If equipped, remove the side turn indicator. - Push the side turn indicator rearward.
- Pull outward from the front and remove the side turn indicator.
| | -
Remove the 2 lower fender bolts. - To install, tighten to 12 Nm (9 lb-ft).
| | -
NOTE:The front door must be open to gain access to the rear fender bolt. Remove the rear fender bolt. - To install, tighten to 12 Nm (9 lb-ft).
| | -
Remove the radiator support brace fender bolt. - To install, tighten to 12 Nm (9 lb-ft).
| | -
NOTE: On the RH side, the antenna base is mounted to the body inside the fender opening. The RH fender must be lifted over the base during removal. Remove the 4 upper fender bolts and the front fender. - To install, tighten to 11 Nm (8 lb-ft).
| | -
To install, reverse the removal procedure. | | |