Removal and Installation Removal and Installation | -
Remove the screw and the rear door trim panel bracket. | | -
Position the watershield aside. | | -
Connect the window control switch electrical connector. | | -
Using the window control switch, lower the rear door window glass to gain access to the rear door window glass screws. | | -
Disconnect the window control switch electrical connector. | | -
Remove the 2 rear door window glass screws. - To install, tighten to 5 Nm (44 lb-in).
| | -
Support the rear door window glass in the full up position. | | -
Disconnect the rear door window motor electrical connector. | | -
Remove the 3 rear door window regulator and motor bolts. - To install, tighten to 6 Nm (53 lb-in).
| | -
Remove the 2 nuts and the rear door window regulator and motor. - To install, tighten to 6 Nm (53 lb-in).
| | -
To install, reverse the removal procedure. | | |