ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Door Lock Control Switch > < Ignition Lock Cylinder

Maverick 2005 (08.2004-)

Handles, Locks, Latches and Entry Systems - Liftgate Window Latch Maverick 2005 (08/2004-)
Removal and Installation

Removal and Installation

NOTE:
NOTE:Make sure the liftgate window glass is in the raised position.
  1. Remove the liftgate trim panel. For additional information, refer to Section 501-05 Interior Trim and Ornamentation.

  1. Disconnect the liftgate window latch.
    1. Disconnect the liftgate window latch ajar switch electrical connector.
    1. Open the clip and disconnect the actuating rod.

  1. NOTE:
    NOTE:Mark the position of the liftgate window latch prior to removing the liftgate window latch bolts.
    Remove the 2 bolts and the liftgate window latch.
    • To install, tighten to 12 Nm (9 lb-ft).
  1. NOTE:
    NOTE:The liftgate window latch must be checked to make sure the latch is installed and aligned correctly.
    To install, reverse the removal procedure.

Door Lock Control Switch > < Ignition Lock Cylinder