Removal and Installation Name Specification Krytox Grease WSS-M1C248-A Removal and Installation | -
Position the rear door glass top run aside. - Remove the 2 bolts.
1. To install, tighten to 8 Nm (71 lb-in). - Position the rear door glass top run aside.
| | -
Disconnect the rear door latch electrical connector. - Release the clip.
- Disconnect the electrical connector.
| | -
Disconnect the exterior door handle actuating rod. - Open the clip.
- Disconnect the actuating rod.
| | -
Remove and discard the 3 rear door latch bolts. - To install, tighten to 8 Nm (71 lb-in).
| | -
Remove the rear door latch from inside the door frame. | | -
To install, reverse the removal procedure. - Lubricate the rear door latch to striker surfaces after installation.
| | |