| Removal and Installation Removal and Installation CAUTION:Prior to removal of the front bumper cover, place tape at the corners of the bumper cover and below the headlamps to prevent damage to the paint. | | -
Remove the 2 rear bumper cover-to-splash shield bolts (1 each side). - To install, tighten to 8 Nm (71 lb in).
| | | -
CAUTION:When removing the outer rear bumper cover pin-type retainers, use caution to prevent breaking the outer rear bumper cover mounts. Remove the 2 center and 2 outer rear bumper cover pin-type retainers. | | | -
Remove the 6 rear bumper cover screws. | | | -
Remove the 2 liftgate alignment bumper bolts and the 2 liftgate alignment bumpers. - To install, tighten to 8 Nm (71 lb-in).
| | | -
Remove the rear bumper cover. | | | -
To install, reverse the removal procedure. - When installing, position the rear bumper cover into the bumper slides.
| | |
