ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
501-25A Body Repairs - General Information > < Occupant Classification Sensor - Service Kit

Maverick 2005 (08.2004-)

Supplemental Restraint System - Passenger Air Bag Deactivation (PAD) Indicator Maverick 2005 (08/2004-)
Removal and Installation

 
Item
Part Number
Description
1
4302
Instrument panel center trim panel
2
—
Passenger air bag deactivation indicator

Removal and Installation

WARNING:
WARNING:Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
WARNING:
WARNING:To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
NOTE:The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE:
NOTE:Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
NOTE:
NOTE:The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
  1. Depower the system. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering.
  1. Detach the retaining clips and partially remove the instrument panel center trim panel.

  1. Remove the passenger air bag deactivation indicator.
    1. Release the red disconnect deterrent tab.
    1. Disconnect the connector.
    1. Release the 2 tabs (one shown).
    1. Remove the passenger air bag deactivation indicator.
  1. To install, reverse the removal procedure.
  1. Repower the system. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering.

501-25A Body Repairs - General Information > < Occupant Classification Sensor - Service Kit