ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Driver Air Bag Module > < Air Bag Control Module

Mondeo 1997 (08.1996-09.2000)

Supplemental Restraint System - Side Impact Sensor Mondeo 1997 (08/1996-09/2000)
Removal and Installation

Removal

WARNING:
WARNING:To minimize the possibility of premature deployment, do not use radio key code savers when working on the supplemental restraint system. Failure to follow this instruction may result in personal injury.
WARNING:
WARNING:Never probe the electrical connectors of air bag modules or any other supplemental restraint system component. Failure to follow this instruction may result in personal injury.
  1. Remove the front seat. For additional information, refer to Section  501-10 Seating.
  1. Remove the cowl side trim panel. For additional information, refer to Section  501-05 Interior Trim and Ornamentation.

  1. Detach the floor covering from the floor panel.

  1. Detach the side impact sensor from the floor panel.

  1. Remove the side impact sensor.
    • Disconnect the electrical connector.

Installation

  1. WARNING:
    WARNING:Never probe the electrical connectors of air bag modules or any other supplemental restraint system component. Failure to follow this instruction may result in personal injury.
    CAUTION:
    CAUTION:Make sure the safety belt shouder height adjuster is set to the lowest position. Make sure the B-pillar upper trim panel is correctly located on the safety belt shoulder height adjuster.
    To install, reverse the removal procedure.

Driver Air Bag Module > < Air Bag Control Module