ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Camshaft Seal > < Valve Seals

Mondeo 2001 (10.2000-02.2007)

Engine - 3.0L Duratec-SE (VE6)/3.0L Duratec-ST (VE6) - Exhaust Manifold LH—3.0L Duratec-SE (VE6) Mondeo 2001 (10/2000-02/2007)
In-vehicle Repair

Removal

  1. Remove the engine cover.

  1. Disconnect the left-hand heated oxygen sensor (HO2S) electrical connector.
  1. Remove the dual converter y-pipe.
    For additional information, refer to: Dual Catalytic Converter Y-Pipe (309-00 Exhaust System, Removal and Installation).

  1. CAUTION:
    CAUTION:Remove the left-hand exhaust manifold retaining nuts in the sequence shown.
    Remove the left-hand exhaust manifold (engine shown removed for clarity).
    • Discard the gaskets and retaining nuts.

Installation
  1. NOTE:
    NOTE:Install new gaskets and retaining nuts.
    Install the left-hand exhaust manifold.
    • Tighten the nuts in the sequence shown.
  1. Install the dual converter y-pipe.
    For additional information, refer to: Dual Catalytic Converter Y-Pipe (309-00 Exhaust System, Removal and Installation).

  1. Connect the HO2S sensor electrical connector.
  1. Install the engine cover.

Camshaft Seal > < Valve Seals