Leave the vehicle for at least a minute without shaking or loading it before headlamp adjustment.
All vehicles
Stand the vehicle on a level surface.
Check that the tyre pressures meet the specifications and that the vehicle is not excessively laden.
Switch on dipped beam.
Set up the measuring screen of the beam setting device to the correct headlamp setting value.
NOTE:Turn on the ignition key to position ""2”, to adjust the headlamp levelling according the vehicle load.
NOTE:After replacing the left-hand headlamp assembly (Master), the system has to be initialized with WDS before the headlamp adjustment.
Adjust the headlamp so that the boundary line touches the horizontal line.
NOTE:A stray portion of the dipped beam may cross the 15 degree line.
NOTE:Readjustment of the vertical axis may be necessary following adjustment of the horizontal axis.
Adjust the dipped beam so that the rising line of the light/dark boundary lies in the intersection point of the horizontal line and the 15 degree line.