Mustang V8-302 5.0L HO (1987)
COATINGS TO BE APPLIED:
^
BASF # 900
^
PPG # DX-330
^
S-W # R7-K158
^
DuPont 3900S
^
Sikkens M600
^
Spies Hecker # 7010
^
ICI # P850-1402
WARNING:
SOME OF THE PRODUCTS SHOWN IN THIS TECHNICAL SERVICE BULLETIN ARTICLE MAY CONTAIN ISOCYANATES. USE A
NIOSH/MSHA OR OSHA APPROVED "SUPPLIED AIR RESPIRATOR" OR "AIR SUPPLIED HOOD" IN CONFINED AREAS FOR
RESPIRATORY PROTECTION. USE APPROPRIATE SKIN AND EYE PROTECTION.
ANTI-CORROSION - SELF ETCH PRIMER
5.
Tack off the bare metal surface and apply two medium wet coats (.5 mil total) of self-etching, anti-corrosion primer using the manufacturer's label
recommendations and flash times.
^
BASF # DE-17
^
PPG # DX-1791
^
S-W # E2-G980
^
DuPont # VARIPRIME 615S
^
Sikkens # WASHPRIMER CR
^
Spies Hecker # 3688
^
ICI # P565-597 OR 565-713
PRIMER SURFACER
6.
Tack off and apply three medium wet coats (2.0 mils total) of acrylic urethane primer/surfacer following the manufacturer's label recommendations
and flash times.
^
BASF # DP-20
^
PPG # K-36
^
S-W # P6-H49/P6-A48/P6-A47
^
DuPont # 1120S
^
Sikkens # AUTOCRYL FILLER
^
Spies Hecker # 5100/8590
^
ICI # P565-761
7.
Sand the vehicle using one of the following methods:
-
Wet-sand by hand using 400 grit or finer sandpaper.
-
Dry-sand by hand using 320 grit or finer sandpaper.
This step will remove approximately .5 mils of material.
8.
Clean off the entire vehicle to remove loose dust and debris.
PRE PAINT CLEANING
9.
Wipe the entire vehicle with a wax and grease remover type product.
^
BASF # 901 PRE-PAINT CLEANER
^
PPG # DX 220
^
S-W # R7-K158
^
DuPont # 3901S FINAL KLEAN
^
Sikkens # M-600
^
Spies Hecker # 7010
^
ICI # P850-14
10.
Tack off all primed surfaces.
TOP COAT APPLICATION
