Mustang V8-4.6L DOHC VIN R (2003)
6. CAUTION: Installation without the correct tools can result in early seal failure.
Place the inboard CV joint stub shaft pilot bearing housing seal onto the special tools.
7. CAUTION: If the inboard CV joint stub shaft pilot bearing housing seal becomes misaligned in the bore during installation, remove it and install
a new one.
Carefully align the inboard CV joint stub shaft pilot bearing housing seal in the housing bore and install the seal.
8. CAUTION: Use special tool 205-461 to avoid damaging the new inboard CV joint stub shaft pilot bearing housing seal when installing the
halfshaft.
Install the halfshaft.
^
If the knuckle and halfshaft were removed as an assembly, refer to Axle Housing. If the halfshaft was removed from the knuckle, refer to
halfshaft.