Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Parking Brake Control: Service and Repair
Rear Parking Brake Control Components
CAUTION: If any component in the parking brake system requires service or if the rear axle housing is removed, the cable tension must be released.
CABLE TENSION RELEASE
1. Remove console top panel.
2. With an assistant inside vehicle, raise and support vehicle.
3. From under the vehicle, pull parking brake cable and equalizer rearward approximately 26-63 mm (1 to 2-1/2 inches) to rotate self-adjuster reel
backward.
CAUTION: Do not remove the steel lockpin until the parking brake rear cable and conduits are connected to the parking brake cable and
equalizer. Pin removal releases the tension in the ratchet wheel causing the spring to unwind and release tension. If the pin is removed without the
parking brake rear cable and conduit attached, the entire assembly must be removed to reset spring tension.
4. Insert a steel lockpin through holes in lever and parking brake control assembly. This locks ratchet wheel in the cable-released position.
CONTROL REMOVAL
1. Disconnect parking brake cable and equalizer from parking brake control.
2. Remove bolts retaining parking brake control assembly to floorpan.
3. Remove parking brake control assembly.
