Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Timing Chain Guides
18. Install RH and LH timing chain guides and secure with three bolts on each. Tighten bolts to 8-12 Nm (71-106 inch lbs.).
19. Lubricate timing chain tensioner arm contact surfaces with clean engine oil meeting Ford specification WSS-M2C 153-F and install RH and LH
timing chain tensioner arms using one bolt each. Tighten to 10-15 Nm (89-132 inch lbs.).
NOTE: Do not remove lock pins until timing chain guides are installed.
20. Install RH and LH primary timing chain tensioners and secure with two bolts on each. Tighten bolts to 20-30 Nm (15-22 ft. lbs.).
21. Remove lock pins from primary timing chain tensioners and make sure all timing marks are aligned.
22. Remove Camshaft Positioning Tool T93P-6256-A.
23. Remove Camshaft Holding Tool T93P-6256-AH.
NOTE: When cleaning sealing surfaces of the engine front cover and oil pan-to-cylinder block joints, use extreme caution not to damage the
rubber bead of the oil pan gasket (6710). If a leak should occur upon reassembly, remove the oil pan and replace the oil pan gasket.
24. Install engine front cover.
25. Start engine and check for leaks and proper operation.
