Mustang Cobra V8-4.6L DOHC VIN V (2000)
Disconnect the driveshaft from the rear axle pinion flange, and wire it out of the way.
7. Note: The following halfshaft and knuckle assembly removal steps apply to both sides of the vehicle.
Disconnect the parking brake cable and conduit from the parking brake lever and the caliper.
8. Separate the parking brake cable and conduit from the knuckle.
9. Remove the rear brake disc.
^
Remove the rear brake caliper and support bracket from the knuckle as an assembly. Wire the caliper and support bracket assembly out of the
way.
10. Remove the rear brake anti-lock sensor and position it aside.
11. Support the lower suspension arm and bushing with a jack stand.
12. Remove and discard the nut and bolt.
