Probe V6-153 2.5L DOHC (1994)
19.
Install four (4) mounting bolts using a T-30 TORX socket and ratchet and tighten the bolts to 13 N-m (10 lb.ft.).
20.
Remove the alignment pins and install and torque the remaining two (2) bolts to 13 N-m (10 lb.ft.). Refer to Figure 16.
21.
Install the new pump seal (F3RZ-7A248-A). Ensure that the white stripe is visible all around the pump. Refer to Figure 17.
22.
Visually inspect the case flange for damage or burrs.
