ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

A/T - CD4E Harsh Shift/DTC 678 or P0741 Set|Page 3934 > < A/T - CD4E Harsh Shift/DTC 678 or P0741 Set
Page 2
background image

approximately 105 km/h (65 mph), local speed limits apply. Maintain 105 km/h (65 mph) during Steps 9 and 10.

9.

While observing engine rpm on the NGS press and hold the TCC button on the Transmission Tester. Does the status light on the tester turn green?

^

Yes Proceed to Step 10.

^

No - Check connection and retest. If light still does not activate, refer to Step 6.

10.

While maintaining 105 km/h (65 mph) in 4th gear, press and hold the TCC button on the Transmission Tester. Wait 5 seconds and observe engine
rpm and TSS sensor rpm on the NGS. Accelerate at half throttle. Does turbine speed (TSS) remain within 50 rpm of engine rpm during
acceleration?

^

Yes - Suspected pump body separator plate gasket blow-out. Proceed to Step 11.

^

No - Replace Torque Converter (-7902-). Road test vehicle after repair.

11.

Remove pump assembly from transaxle. Disassemble pump support from pump body, being careful not to damage pump body separator plate
gasket. Compare the gasket to Figure 1. Is the pump body separator plate gasket blown-out?

^

Yes - Proceed to Step 12.

A/T - CD4E Harsh Shift/DTC 678 or P0741 Set|Page 3934 > < A/T - CD4E Harsh Shift/DTC 678 or P0741 Set