Probe V6-153 2.5L DOHC (1994)
or the front wheel driveshaft joint boot.
Installation
1. Install a new driveshaft bearing retainer circlip on the halfshaft.
2. Position the outboard front wheel driveshaft and joint on the halfshaft spline.
3. Push the outboard front wheel driveshaft and joint in until the driveshaft bearing retainer circlip seats correctly in the front wheel driveshaft joint
outer race.
4. Position the front wheel driveshaft and joint through the wheel hub and install a new front axle wheel hub retainer. Do not tighten the front axle
wheel hub retainer at this time.
5. Position the ball joint to the front wheel knuckle and install the ball joint clamp bolt. Tighten the ball joint clamp bolt to 34-57 Nm (25-42 ft. lbs.).
6. Install the RH stabilizer bar link to the front suspension lower arm. Tighten the stabilizer bar link nut to 36-54 Nm (27-40 ft. lbs.).
7. Install a new front axle wheel hub retainer. Tighten the front axle wheel hub retainer to 235-319 Nm (174-235 ft. lbs.). If necessary, apply brakes.
Fig. 7 Staking axle nut
