Probe V6-153 2.5L DOHC (1994)
8. Stake the front axle wheel hub retainer using a cold chisel with the cutting edge rounded as shown.
CAUTION: If the front axle wheel hub retainer splits or cracks after staking, it must be replaced.
NOTE: The staking tool can be fabricated from an existing hardened chisel. The correct radius on the chisel tip will prevent incorrect staking. Do
not attempt to stake with a sharp edged tool.
9. Check the transaxle fluid level and check for transaxle leaks.
10. Install the RH wheel and tire assembly and the five lug nut. Tighten the lug nuts to 88-118 Nm (65-87 ft. lbs.).
11. As a final inspection, rotate the RH front wheel driveshaft and joint by hand and observe the operation of the RH front wheel driveshaft and joint.
12. Lower the vehicle.
