Probe V6-153 2.5L DOHC (1994)
3. Use an arbor press to install a new inboard driveshaft inner dust seal.
4. Use an arbor press to install the halfshaft into the front axle bearing bracket.
5. Install a new driveshaft bearing retainer circlip on the outboard end of the halfshaft.
CAUTION: The original driveshaft bearing retainer circlip must not be reused.
NOTE: To prevent overexpanding, install the new driveshaft bearing retainer circlip by starting one end of the driveshaft bearing retainer circlip
in the driveshaft bearing retainer circlip groove and working the driveshaft bearing retainer circlip over the end of the halfshaft.
6. Ensure that the driveshaft bearing retainer circlip gap is positioned at the top and lubricate the halfshaft splines with the same lubricant the
transaxle requires.
7. Remove the Transaxle Plugs T88C-7025-AH from the transaxle.
8. Inspect the differential oil seal for wear or damage and replace as necessary.
9. Position the halfshaft to the transaxle so that the halfshaft splines are aligned with the differential side gear splines.
10. Push the halfshaft into the differential until the driveshaft bearing retainer circlip is felt to seat in the differential side gear.
11. Position the front axle bearing bracket and install the three front axle bearing bracket bolts. Tighten the front axle bearing bracket bolts to 42-62
Nm (31-46 ft. lbs.) in the
12. Install the outboard, RH front wheel driveshaft and joint.
