Probe V6-182 3.0L (1990)
Figure 8
Figure 9
WATER LEAKAGE IN THE COWL AREA
If water leakage is still observed, refer to the 1991 Probe Shop Manual, Section 01-00, pages 2, 3, 4 and 5, for application of sealer to the side of the
cowl behind the right front fender. Follow the procedures as described below to seal behind the right front fender. See Figures 6 through 9 for sealer
locations.
1.
To access the seam areas behind the fender, remove the bolts that hold the fender to the body from the following locations:
^
Two (2) screws behind the right headlamp cover plastic bezel
^
Along the top of the fender
^
Along the "A" pillar
^
At the bottom of the fender to the bottom of the cowl
^
Around the wheel opening
2. Lift the rear edge of the fender and pull it outboard.
NOTE:
COMPLETE FENDER REMOVAL IS NOT REQUIRED FOR PERFORMING THE RESEALING OPERATION. THE FIGURES IN THE