Ranger 2WD V6-177 2.9L (1989)
Headlamp Switch: Service and Repair
Fig. 11 Headlamp Switch Replacement.
1.
Disconnect battery ground cable, remove ash tray assembly and two finish panel retaining screws, then the finish panel (snaps off).
2.
On Bronco II or Explorer models, remove rear window wash/wipe and heated backlit switch assembly (snaps out).
3.
On Ranger models, remove storage bin (snaps out).
4.
On all models, pull headlamp switch knob to ON position, then depress shaft release button on switch and remove knob and shaft assembly, Fig.
11.
5.
Remove bezel nut, pull switch down through opening, disconnect electrical connector, then remove switch.
6.
Reverse procedure to install.
