Ranger 2WD V6-3.0L (2008)
-
To install, tighten to 8 Nm (71 lb-in).
6. Remove the 2 radiator bolts and tilt the radiator rearward.
-
To install, tighten to 7 Nm (62 lb-in).
7. Remove the pin-type retainers and remove the top seal.
8. NOTE: It may be necessary to remove the radiator from the mounting saddles to provide clearance for the condenser core removal.
Remove the 2 condenser core bolts and the condenser core.
-
To install, tighten to 12 Nm (9 lb-ft).
9. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
10. Evacuate, leak test and charge the refrigerant system.
