Ranger 2WD V6-4.0L (2010)
Seat Cushion: Service and Repair
Seat Cushion - Front, 60 Percent
Seat Cushion - Front, 60 Percent
Disassembly and Assembly
NOTE: For parts identification and location, refer to Seat - Exploded View, Front See: Service and Repair/Front Seat/Seat - Exploded View, Front.
1. Remove the seat cushion cover. For additional information, refer to Seat Cushion Cover - Front See: Seat Cover/Service and Repair/Seat Cushion
Cover - Front.
2. Remove the wire harness.
-
Disconnect the electrical connectors and detach the wire harness retainers.
3. Remove the seat track. For additional information, refer to Seat Track - 60 Percent See: Seat Track/Service and Repair/Seat Track - 60 Percent.
4. Remove the 2 screws and seat position sensor.
5. Detach the pin-type retainer and remove the backrest latch release cable.
-
Note the cable routing for correct installation.
6. Remove the seat cushion foam pad.
7. To install, reverse the disassembly procedure.