Ranger 4WD V6-245 4.0L VIN X SFI (1999)
^
Position the extension housing and install the six extension housing screws and studs.
3. Install the transmission mount.
1
Position the transmission mount on the extension housing.
2
Install the screws.
4. Install the transmission mount into the crossmember and tighten the nuts.
5. Install the wire harness locators from the extension housing wire bracket.
6. Install the transfer case.
7. NOTE: Align the driveshaft with the marks made during removal to ensure correct balance.
Align and install the rear driveshaft.
8. Install the bolts.
9. Connect the battery ground cable.
