Ranger 4WD V6-3.0L VIN U (1997)
Retainer Clip And Spring Washer
13. Remove the parking brake lever from the secondary rear brake shoe and lining.
INSTALLATION
1. Clean the ledge pads on the brake backing plate.
2. Apply a light coating of Disc Brake Caliper Slide Grease D7AZ-19590-A or equivalent meeting Ford specification ESA-M1C172-A at the points
where the brake shoes touch the brake backing plate.
3. Before installing the rear brake shoes and linings, assemble the parking brake lever on the secondary shoe and, on ten-inch brakes, secure with the
spring washer and parking brake lever pin retainer.
Parking Brake Lever Link And Parking Brake Rear Cable
4. Position the rear brake shoe and lining on the brake backing plate, and install the brake shoe hold-down spring pins, brake shoe hold-down springs,
and brake shoe hold-down spring cups using a hold-down spring tool. Install the primary brake shoe parking brake lever link, parking brake link
spring, and washer. Connect the parking brake rear cable and conduit to the parking brake lever.
