Ranger 4WD V6-3.0L VIN U (1997)
INSTALLATION
1. Position the EGR vacuum regulator solenoid and install the nuts. Install EGR vacuum regulator bracket nut. Tighten EGR vacuum regulator
solenoid nuts to 8-12 N.m (6-8 lb ft).
2. Position ignition coil and radio ignition interference capacitor to ignition coil mounting bracket.
3. Install two ignition coil nuts and top ignition coil mounting bracket nut. Tighten to 16-20 N.m (12-14 lb ft).
4. Apply Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19331-A (Motorcraft WA-10), or equivalent meeting Ford specification
ESA-M1C171-A to all spark plug wire boots.
5. Install each spark plug wire connector to the proper terminal on the ignition coil. Make sure spark plug wire boots are fully seated.
6. Connect ignition coil and radio ignition interference capacitor electrical connectors.
